Red PLASTIGAGE .051 - .152mm (.002-.006 inch)

Description: Red PLASTIGAGE .051 - .152mm (.002-.006 inch) - One Piece -#SPR-1 This listing is for one piece of a brand new, red PLASTIGAGE clearance indicator thread for use in measurement of clearance in automotive engine bearings. SPR-1 red Plastigage covers a clearance range of .002 to .006 inches (.051 to .152mm). A measurement scale is printed on the included Plastigage package. The thread is composed of a compliant plastic material, and is approximately 12 inches long. Note on Clearance Sizes: RED PLASTIGAGE is suitable for clearance requirements in the range of .002-.006 inches (.051 to .152mm). PLASTIGAGE is also available in other thicknesses for larger clearance specifications. Below is a guide for reference. Note, this listing is only for one piece of RED Plastigage. Green: .001 to .003 inches (.025 to .076mm)Red: .002 to .006 inches (.051 to .152mm)Blue: .004 to .009 inches (.102 to .229mm)Yellow: .009 to .020 inches (.23 to 0.51mm) Tech Tips on Use: Remove the engine oil pan to reveal the big-end and its retaining set-screws. Remove excess oil and release the big-end shells by unscrewing the set-screws. Apply a smear of grease to the journal and small quantity of silicone release agent to the shell. Trim a length of PLASTIGAGE to fit across the journal using the grease to hold it in place. Replace the shell and tighten the set-screws to the recommended torque setting, without rotating the journal. Now remove the shell to reveal the PLASTIGAGE which will have been spread across the bearing surface as a stripe or band. Match the width of the stripe against the calibrated gauge on the package, and read the clearance. The PLASTIGAGE stripe ideally should be removed with a clean oily cloth or degreasing solvent. However, any remaining PLASTIGAGE residue left behind will simply dissolve in motor oil and will not harm the engine in any way.

Price: 7.45 USD

Location: Costa Mesa, California

End Time: 2024-03-10T01:50:19.000Z

Shipping Cost: 0 USD